Free delivery on most orders.
 

Connecting an analogue audio source to the interface module

Applies to:

  • CineMate® GS Series II digital home cinema speaker system
  • CineMate® Series II digital home cinema speaker system

If your TV is not equipped with an optical connector, use the supplied stereo audio cable to connect from your TV Audio OUT connectors to the interface module Analogue IN connectors by following these steps:

Connect the two (red and white) RCA connectors into the left (L) and right (R) audio outputs on the rear panel of your TV

Connect the other end of the RCA cable into the Left (white) and Right (red) analogue inputs on the interface module

Was this helpful?

Submit

Thank you for submitting your comments.